KV2 EPAK2500R

Features

• 4-way modular, rack mount 2500W Control and Amplification System for use specifically with ES Series modules
• High Frequency, 100W, Class AB, push-pull, low intermodulation amplifier with transformer balanced outputs
• Mid Frequency, 200W, Class AB, push-pull, low intermodulation amplifier with transformer balanced outputs
• Mid Bass, 600W, high efficiency, current enhancing switching amplifier Subwoofer, 1600W, high efficiency, current enhancing switching amplifier
• Complete, on board speaker management system including equalization, time alignment, crossover filters, amplifier overdrive protection, system set-up and output level controls
• 20MHz sampling, digital delay alignment system setting new standards for audio performance and dramatically increasing phase response precision
• AC soft start circuitry with ON/OFF AC breaker switch provides thorough power protection Setup provides selection and control of different subwoofer combinations
• External Subwoofer output with independent internal and external Level control +/- 6dB
• High Frequency control +/- 3dB for precise adjustment
• Comprehensive front-to-back cooling system features chassis sealed PCB's for improved reliability
• Line Driver ready – rear mounted Input impedance selector provides selection of optimal input impedance when used with a KV2‘s LD4 Line Driver
• Individual signal inserts for Mid/High, Internal Subwoofer, and External Subwoofer signal paths providing flexibility for insertion of signal processing or feeding from auxiliary sources as required
• Includes cable kit with all speaker cables for a single stack ES system

High Frequency Amplifier Specification

• Type Class AB Push-Pull low inter-modulation Mosfet design with transformer balanced output
• Rated Continuous Power 100W
• Distortion <0.05%
• Operating Bandwidth 2.5kHz to 28kHz

Mid Frequency Amplifier Specification

• Type Class AB Push-Pull low inter-modulation Mosfet design with transformer balanced output
• Rated Continuous Power 200W
• Distortion <0.05%
• Operating Bandwidth 500Hz to 2.5kHz

Mid Bass Frequency Amplifier Specification

• Type High efficiency, Low frequency, Current-enhancing switch mode
• Rated Continuous Power 600W
• Distortion <0.05%
• Operating Bandwidth 130Hz to 500Hz

Low Frequency Amplifier Specification

• Type High efficiency, Low frequency, Current-enhancing switch mode
• Rated Continuous Power 1600W
• Distortion <0.05%
• Operating Bandwidth 20Hz to 130Hz

Signal Input

• Input Sensitivity 1.0V RMS
• Input Impedance 20kΩ (balanced) or 50Ω "Line Driver ready"

Speaker Output

• Speaker Output AP6 (Mid-Hi), AP4 (Sub)

Power Requirements

• Power Connector Neutrik PowerCon®
• Operating Voltage Range 100 to 120V@60Hz | 205 to 240V@50Hz | 225 to 260V@50Hz
• Recommended Amperage 20A 115V | 10A 230V | 10A 250V

Physical Dimensions

• Height 177 mm (6.96")
• Width 481.4 mm (18.95")
• Depth 415.4 mm (16.35")
• Weight 30 kg (66lbs)