• New

Radial Engineering OX8-j


€1,818.00
Tax included

OX8-j


Out of Stock

Free shipping


wishlist

Radial Engineering OX8-j

 

RADIAL engineering OXBj is an 8-channel Passive Micro/Line Splitter with Jensen transformers, ideal for Live recording and Permanent Installations, each channel provides 48 Volt Phantom power,-36db Attenuation Pad and Ground Lift.

Notable features of OXBj

Applications

Using OX8 for recording a live show

OX8 is ideal for recording live shows. Simply connect microphones on stage to OX8 and send their split signal to the recording system and PA System. Transformers isolate the recording system and eliminate Hum and Buzz noise caused by ground loops.

Using OX8 live with a PA System

There is nothing more annoying than the hum and Hum that can come from stage monitors. OX8 is easily configured to isolate the FOH mixer and monitor mixer to ensure complete elimination of noise. Multiple units can be used for 16 or more channels.

Using OX8 for broadcasting a Live event

The auxiliary output can power the monitors, while the isolated output provides the signal to a control truck. OX8's outstanding sound quality provides a distortion-free feed to the broadcaster, allowing the PA system to operate independently.

TECHNICAL SPECIFICATIONS
Audio circuit type:Transformer-based passive microphone splitter
Transformers:choice of Jensen JT-MB-CPC or Radial Eclipse MS10
Number of channels:8
Frequency response:Jensen 20Hz ~ 20KHz (+0dB/-0.2dB), Radial 20Hz ~ 18KHz (+0dB/-3dB)
Dynamic range:Jensen 140dB, Radial 140dB
Total harmonic distortion:Jensen 0.003% @ 1kHz, Radial 0.005% @ 1kHz
Phase deviation:Jensen 0.7° @ 100Hz; 2.8° @ 20Hz, Radial 1° @ 100Hz; 5° @ 20Hz
Input impedance:150 Ohms, balanced
Output impedance:150 Ohms, balanced
Common Mode Rejection Ratio:Jensen -115dB @ 60Hz, Radial 114dB @ 60Hz
Maximum input:Jensen +2dBu @ 20Hz, Radial +2dBu @ 20Hz
Features
Input pad, Ground lift
Input connectors:XLR, Euroblock, DB-25
Output connectors:Euroblock, DB-25
General Features
Construction:14-Caliber steel
Dimensions (L x W x D):19 x 6 x 1.75 (48.25cm x 15.25cm x 4.45cm)
Weight:7.5lb (3.4kg)
Power supply:Passive, does not require power supply
Operating conditions:Between 5°C and 40°C in low humidity conditions
  • XLR microphone input: Standard 600Ώ balance, Input connected in parallel with, the rear panel D-Sub.
  • Channel identification label: area to be able to write with wax pencil and immediately identify the channel, in the instrument configuration.
  • Pad -36db: Reduces input sensitivity, so that even line signals can be connected properly without distortion.
  • Ground Lift: Helps to eliminate ground loops

GRAD8001239

Specific References